I just got the MR today and my 2 y/o fits so well in it!!! I cannot believe how much room she has (as compared with the BLVD). I wasn't overly pleased with the install due to one side adjusting ... and it seemed like even when the latch was tight, there was still some movement (thinking it was less than 1in, but I am used to the BLVD installing with no wiggle room). I uninstalled and reinstalled a few times....by moving the 'foot' a little farther back from the latch connectors (ie. not pushed tight in the bight of the seat), I got a super tight install...but the little ball is slightly out of the green range on the leveler. I figure it means it's really close to 30 degrees--but don't know if it's too far. How accurate is the green leveler/ball? Is it better to have the tighter install? I was able to get tight installs on the BLVD even before doing the rear tether, so I don't think it's that that is throwing me on the MR.
Tips? It's an '07 Saturn Relay and DD is 24months/28lbs and says her nice seat is 'niiiiiiiccccccceeee".
ETA: And, my 5y/o (39lbs) doesn't fit too badly in the seat! He's too tall (head slightly above shell) but his shoulders are below the top slots, but it gives me hope that DD can use this seat for a while.
Tips? It's an '07 Saturn Relay and DD is 24months/28lbs and says her nice seat is 'niiiiiiiccccccceeee".
ETA: And, my 5y/o (39lbs) doesn't fit too badly in the seat! He's too tall (head slightly above shell) but his shoulders are below the top slots, but it gives me hope that DD can use this seat for a while.
Last edited: