mamma bear
New member
Just got a sureride as a secondary convertible. It will be installed rear facing in a 2008 subaru outback. We don't love the outboard latch install (I can't seem to get it tight enough, plus it leaves no room for the front passenger), so I was going to do a center install with the seat belt (I know Subaru discourages center seat installs, but it has worked fine with our keyfit and our nextfit--both installs checked by techs I trust). Based on the manual instructions, it sounds like I don't need to use a locking clip, but just wanted to make sure since I'm still a newbie at all of this... Here's what the manual says...
"Pull out the seatbelt fully from the retractor to change the retractor over from the Emergency Locking Retractor (ELR) to the Automatic Locking Retractor (ALR) function. Then, allow the belt to rewind into the retractor. As the belt is rewinding, clicks will be heard which indicate the retractor functions as ALR."
So...locking clip not needed if I follow these directions, correct?
Thanks in advance!
"Pull out the seatbelt fully from the retractor to change the retractor over from the Emergency Locking Retractor (ELR) to the Automatic Locking Retractor (ALR) function. Then, allow the belt to rewind into the retractor. As the belt is rewinding, clicks will be heard which indicate the retractor functions as ALR."
So...locking clip not needed if I follow these directions, correct?
Thanks in advance!