M
mrsteacher77
Guest
Hi All~ I have been a long time reader and thought I had digested enough information to be able to install my Pria correctly, but I'm not sure. I have a 2011 Lexus RX 350 and have the Pria install RF in the middle seat for my 10 1/2 month old daughter. I don't have Latch in the middle, so it's installed with a seatbelt. My concern is that it is uneven. The seatbelt is pulling up on one side. (Pix below).
I took it in to have it installed by a tech and they did it the same way. Over a few weeks, it was leaning so far over, that I undid it and tried again. This time, I put a rolled up towel underneath to help with the level.
I'm really worried I've done it incorrectly. I would really prefer to have her in the middle. Help!
http://i47.tinypic.com/2gt46r7.jpg
http://i48.tinypic.com/11izq0l.jpg
http://i47.tinypic.com/214wb5h.jpg
I took it in to have it installed by a tech and they did it the same way. Over a few weeks, it was leaning so far over, that I undid it and tried again. This time, I put a rolled up towel underneath to help with the level.
I'm really worried I've done it incorrectly. I would really prefer to have her in the middle. Help!
http://i47.tinypic.com/2gt46r7.jpg
http://i48.tinypic.com/11izq0l.jpg
http://i47.tinypic.com/214wb5h.jpg
Last edited by a moderator: