UPDATED: Pictures of Regent long belt path install without cover on

MsFacetious · May 2, 2007

I think I added the things everyone suggested, let me know if you see anything else I should change.

The purpose of this is to show how you install with the long belt path because there is often confusion and the manual is not clear on it. By taking off the cover I could show where the belts went. Hopefully I covered everything.

http://britaxcarseats.blogspot.com/2007/04/britax-regent-long-belt-path.html

Thanks!

lovemyfamily · May 2, 2007

Did you happen to see the photos of my Regent install? Can't remember if you responded or not. The shoulder belt on mine is not long enough to go over the very top of the seat, but goes over that second, sort of bump on the side top. I have a post here with the photos.

Here is the thread with my photos:
http://www.car-seat.org/showthread.php?t=15742

mom2acrew · May 3, 2007

Chelsae, Just a quick comment on the Regent, I believe the seat belt should go between the harness and the shell on the back of your long belt path install so it does not interfere w/ tightening the harness.

MsFacetious · May 3, 2007

That is not what everyone else has told me. It does not interfere with tightening the harness, but if it goes between the harness and the shell it does interfere. The shoulder belt pulls up on one side of the harness.

I will call Britax.

arly1983 · May 3, 2007

Looks good to me...

And I know exactly what you mean about the harness. I have to put it on top too..

MsFacetious · May 3, 2007

I will call Britax tomorrow Lol I was going to go outside to get the serial number and stuff... and it is HAILING. Not that important to call today! Lol.

UPDATED: Pictures of Regent long belt path install without cover on

MsFacetious

New member

lovemyfamily

New member

mom2acrew

Moderator - CPST Instructor

MsFacetious

New member

arly1983

New member

MsFacetious

New member

Car-Seat.Org Facebook Group

Sponsors

Forum statistics