Need tether anchor part #

scatterbunny · Jan 2, 2007

For a 1993 Ford F-150 single cab (center spot).

Also, does it say if there are pre-drilled holes? I'm probably going to get a KidY/RideRyte combo for this truck and was wondering about just using EZOn's tether anchor kit instead of going through Ford.

bensmom · Jan 2, 2007

The info I have for the F-150 (1993) is:

Front seat - part E5TZ 15613D20-A. (2) Drill dimples and slots in the back wall. For models with center-facing jump seats, install and use a CRS with tether only in front center position if passenger side rear seat is to be occupied.

Rear seat, center - E5TZ 15613D20-A - Drill dimple and slot in back wall.

There's a note that says: Drill dimples and slots in back wall can be used to tether child restraints in front seat of regular cab or SuperCab with center-facing seats, or in rear seat of crew cab or SuperCab with forward-facing rear seats.

HTH!

scatterbunny · Jan 3, 2007

Thanks. I think I got these part #'s awhile back but when I searched I couldn't find the post.

I believe when I searched I found it would be $68 for one kit. I wonder, does Ford have a bulletin that says they will do it for free?

And what do you think about just using the EZOn kit instead of going through Ford? Or will Ford need to drill?