Judi
CPST/Firefighter
Ok, a step by step on how to change the harness level. This is for a Dorel (Safety 1st, Eddie Bauer, Cosco) infant car seat without a splitter plate. Here is the bottom of the car seat:
Here is the clip at the end of the hip part of the harness:
Slip the clip off the harness:
Pull out:
Now start sliding the chest clip and buckle tongue through shoulder slot:
Moving the harness to the appropriate height (always at or below the shoulders) and repeat in backwards order.
Here is the clip at the end of the hip part of the harness:
Slip the clip off the harness:
Pull out:
Now start sliding the chest clip and buckle tongue through shoulder slot:
Moving the harness to the appropriate height (always at or below the shoulders) and repeat in backwards order.
Last edited: