U
Unregistered
Guest
We have three RF in our Mazda 5 two in Radians XTSLs and one in a Marathon 70. With the new angle adjuster we're finally able to put one of our Radian XTSLs RF in the 3rd row. It's braced on one of the 2nd row seats. Should we still tether it and if so can we use the tether point on one of the 2nd row captain's chairs since the other Radian XTSL in it is also RF and tethered on one of the 1st row seats? I wasn't sure if the tether is really needed since it's already braced on the 2nd row seat. The Marathon 70 is also very slightly braced on one of the 2nd row seats. Should we tether it and if so where?
Also, anyone have issues with the Super Latch on the Radians in their Mazda 5? Both of ours came loose RF and I called Diono and got a replacement. Based on their instructions I just cut out the old strap and can attach the new one with a plastic pull tie to the back of the seat if I wish. Does this mean I could just cut that connector strap off and keep the Super Latch strap? I'm assuming that connector strap serves no safety purpose. It's been a pain sometimes when I've tried to tighten the Latch and if I could just get rid of it, I think it would make for an easier install.
Many thanks!
Also, anyone have issues with the Super Latch on the Radians in their Mazda 5? Both of ours came loose RF and I called Diono and got a replacement. Based on their instructions I just cut out the old strap and can attach the new one with a plastic pull tie to the back of the seat if I wish. Does this mean I could just cut that connector strap off and keep the Super Latch strap? I'm assuming that connector strap serves no safety purpose. It's been a pain sometimes when I've tried to tighten the Latch and if I could just get rid of it, I think it would make for an easier install.
Many thanks!