U
Unregistered
Guest
I have an Evenflo SecureKid 400 for my 5yo son but he's just about to outgrow the highest shoulder strap on the 5-point-harness. I am reading up on installation for use as a high back booster using the seat belt vs harness but I am having a very hard time figuring out whether the seat should be installed with the lower latch anchors or not. No where in the manual does it say to attach the seat in booster mode to the car with the latch system/upper tether but no where does it say not to either. It's very vague and confusing. I have tried reading up online and have found a a couple places that say this seat can be connected with the latch while using as a high back booster with the seat belt but I can't find a solid answer whether the correct way is or without or if it matters and which is safer? I'm assuming the seat belt will still work properly and keep my son safe if the seat is attached to the latch system?
I'm just not sure what to do. Does anyone have this seat or have an answer? We also have a Graco TurboBooster for my husband's car and that is just one that sits on the seat without attaching in anyway, just a positional booster. I appreciate any advice. I will probably contact Evenflo as well for clarification.
Thanks in advance!
Ali
I'm just not sure what to do. Does anyone have this seat or have an answer? We also have a Graco TurboBooster for my husband's car and that is just one that sits on the seat without attaching in anyway, just a positional booster. I appreciate any advice. I will probably contact Evenflo as well for clarification.
Thanks in advance!
Ali