lpperry
Active member
I have a Graco Snugride. When I install it in my 2002 Subaru (no latch), the ALR seatbelt causes it to tip to one side. This happens in all three back seat positions.
Someone here suggested I use the locking clip instead of the ALR. When I installed it with the locking clip, the buckle comes up too far. The locking clip would have to be laying in the base of the carseat. Anyone know if this is ok? Or any suggestions of what to do?
By the way, my baby Oliver was born April 8th. I was looking at my Graco manual trying to figure out how to work this locking clip when I went into labor! So, now I have a baby and need to figure out this carseat! We've been using my husband's car, which has latch.
Someone here suggested I use the locking clip instead of the ALR. When I installed it with the locking clip, the buckle comes up too far. The locking clip would have to be laying in the base of the carseat. Anyone know if this is ok? Or any suggestions of what to do?
By the way, my baby Oliver was born April 8th. I was looking at my Graco manual trying to figure out how to work this locking clip when I went into labor! So, now I have a baby and need to figure out this carseat! We've been using my husband's car, which has latch.
Last edited: