Telluride

[Unregistered]

Can anyone PLEASE give me any information regarding seatbelt overlap in the Kia Telluride and being able to safely install a seat in 2C with a seatbelt and 2D with the LATCH? Thank you!

[MelodyoftheForest]

On the photo I found, I can’t tell where the lower anchors are compared to the center belt.

If the lower anchors is clearly closer to the side of the car than the belt, I don’t see a problem. If it is unclear, I would install the seat in the center with the belt first, then see if the lower anchor clip goes in without touching/pushing on the center belt when you install the outboard seat.

I had a similar situation in a vehicle and found that the center belt was not in the way when in use. Your situation could be very different, of course. You will probably have to try it yourself as it’s a new vehicle that not many people have installed seats in.