F
FrenchFries27
Guest
Hello,
I'm attempting to install a Diono Radian RXT in my 2015 Subaru Forester. The bight of the seat is a few inches higher than the normal crease , so I read somewhere to put the feet of the Diono at the "normal" bight instead of trying to fit it into the raised bight. While trying to install the seat rear-facing (daughter is almost 4 yrs. old - 32 lbs., not sure of height), the belt strap from the Super Latch became twisted and now I can't untwist it. I'm super frustrated and am hoping someone has some tips on untwisting this SuperLatch belt. I'm specifically referring to the part where there's a metal tab to tighten or loosen the strap. One side of the belt is flipped over and has fed through the buckle that way, making it very difficult to unflip. Anyone have any recommendations, please feel free to reply. Thanks in advance!!!
I'm attempting to install a Diono Radian RXT in my 2015 Subaru Forester. The bight of the seat is a few inches higher than the normal crease , so I read somewhere to put the feet of the Diono at the "normal" bight instead of trying to fit it into the raised bight. While trying to install the seat rear-facing (daughter is almost 4 yrs. old - 32 lbs., not sure of height), the belt strap from the Super Latch became twisted and now I can't untwist it. I'm super frustrated and am hoping someone has some tips on untwisting this SuperLatch belt. I'm specifically referring to the part where there's a metal tab to tighten or loosen the strap. One side of the belt is flipped over and has fed through the buckle that way, making it very difficult to unflip. Anyone have any recommendations, please feel free to reply. Thanks in advance!!!