This has to be one of the easiest vehicles to install car seats in. It has three complete sets of latch anchors (yes, three lower sets).
I just installed a RF Boulevard in the middle and RF Roundabout outbound. All with latch. Super super easy. Both front seats are able to be all the way back. If the Boulevard had been outboard, the front seat may have needed to move up just a smidge.
I could have easily put in a third seat this size.
ETA: The top tethers are attached in an unusual way. There is a metal bar under a plastic cap above the back seat. It looks like the top tether anchors in a sedan. I just realized these are NOT the tether anchors. Please take a look at the car manual for exact specifics, but basically the tether is just routed through these metal bars and actually attaches to an anchor on the floor of the vehicle near the edge of the seat for outboard or near where the middle LATCH anchors are for the middle. I haven't had a chance to install car seats yet with this new info.
I just installed a RF Boulevard in the middle and RF Roundabout outbound. All with latch. Super super easy. Both front seats are able to be all the way back. If the Boulevard had been outboard, the front seat may have needed to move up just a smidge.
I could have easily put in a third seat this size.
ETA: The top tethers are attached in an unusual way. There is a metal bar under a plastic cap above the back seat. It looks like the top tether anchors in a sedan. I just realized these are NOT the tether anchors. Please take a look at the car manual for exact specifics, but basically the tether is just routed through these metal bars and actually attaches to an anchor on the floor of the vehicle near the edge of the seat for outboard or near where the middle LATCH anchors are for the middle. I haven't had a chance to install car seats yet with this new info.
Last edited: