Installing a RF Boulevard in a Honda Fit

[debbaxara]

Hi,

I've got a Honda Fit and just purchased the Britax Boulevard. I've got the seat installed well using the LATCH but cannot figure out where to anchor the tether when it is rear facing. Any suggestions?

[Pixels]

Which seating position is it in? If it's in the center, you cannot use LATCH. You must use the seatbelt instead, as there is no LATCH in that position and Honda does not allow borrowing.

Move the front seat forward. Look at the track that the seat moves in. At the back, there is a plastic piece that covers the back of the track and the leg. Pop it off (it comes off easily if you spread it a bit). The track is super greasy, so wipe off any extra gobs that aren't on the track. Loop the D-ring around the leg. Move the seat back into the position you want.Then you can connect the top tether. Any time you want to move the seat, you must loosen the tether first, move the seat, then tighten it back up when you're done.