need info on Eddie Bauer 3in1

[dd9736]

DH just brought home the eddie bauer 3in1 carseat for our DS, he is 8months old, 16-17lbs, and 70cm tall. I tried DS in the carseat fully reclined, as the instructions state, and could not get the harness slots below his shoulders, even on it's lowest setting, they were sitting at his shoulders, while he was wearing a bulky bedtime cloth diaper, which adds an extra 1/2" from the seat to his shoulders.
How can the manufacturer, or anyone else claim that a newborn could fit in this seat? DS has outgrown his old seat by height, yet is to short for the straps on this seat.
I would like to get some more info on the seat, just incase DH doesn't agree that it doesn't fit properly.

[Jewels]

Here is a list a member here made up

Eddie Bauer/AO/AOE
Cons list:
1. This WILL NOT BE THE ONLY SEAT YOU WILL EVER NEED!! Reason being... Carseats expire after 6 years max (plastic starts to break down after 5 years and the seat can have hidden damage and fail in a crash). Children need to ride in a booster seat until they are 8-10 years old and at least 4ft 9in tall. Also there are new advances on carseats all the time and in 6 years there will be lots of new information and new seats out that will be better. You will need to purchase a new seat after your AO expires.
2. There have been problems with the harness straps twisting. You may or may not have a problem with this, but something to be aware of and for others to know. These MUST be untwisted EVERY SINGLE RIDE and need to lie flat against the body.
3. The harness slots are rather low on this seat and your child may outgrow it by height before weight and making them need the belt position booster when they should still be in a harness (should be in a harness until at least 40lbs).
4. The back on the booster is not all that high and will probably be outgrown by a child at about 60lbs (tips of ears are even with the top of the shell).
5. The AO is designed with less head/side support then other convertibles in order to accommodate the later belt-position booster. But yet it offers too much side support for a belt position booster and it could cause the shoulder belt to be held away from the child’s body and in a crash the child could slip out from under the belt.
6. The chest clip tends to slide down when in use and the clip needs to stay at armpit level in order to prevent ejection from the seat and car in the event of a crash. Cosco is aware of this problem and has redesigned the clip, but some models still have the old clip.
7. This seat can be very difficult to install in many vehicles. It has many incompatibility issues. Some of which cannot be fixed and a different seat is recommended.
8. Seat shell may crack in extreme heat. This renders the seat completely useless. Cosco is not at all surprised this accurse and Cosco customer service says (according to one mom who spoke with customer service) "sometimes that happens on these seats when you have a hot spell".
From Consumer Reports…
9. When used a belt position booster (with out the harness) the belt guide can stick causing the belt to have slack. The child could slip out from under it in the event of a crash.
10. Also when used as a belt position booster (also with other Cosco boosters) children can slip out from under the lap belt portion in a crash.
New info I have learned about Cosco as a company: First, Cosco has several lawsuits filed against them right now for allegedly selling dangerous seats. They are aware of many problems with certain seats and refuse to pull them from store shelves as they “pass all federal safety standards”. The reason these seats pass standards is because they are only TESTED in frontal collisions, but the in real life results have been much different and unfortunately it has resulted in many children being seriously injured, paralyzed, and killed. Second, Cosco has been fined by the government many, many times for reporting false information to NHSTA about their seats. Third, Cosco will wait until they absolutely HAVE to put a recall out on one of their seats before doing so. This to me tells me they are a company out for a few $$ instead of worrying about children’s lives

Personally I don't think this is the worst seat out there and if you can get a good fit, a good install and use it correctly every time it could be the seat for you. It won't last forever, will likely be expired before outgrown (as a booster that is) and won't last that long as a FF 5pt harnessed seat due to low top harness slots. If at all possible I would recommend a seat with a higher top harness to begin with as it will save you money in the long run.

[papooses]

Most kids outgrow the harness before they're truly ready for a booster, then they outgrow the booster before they can safely ride without one -- I'd exchange it for a Safety 1st Uptown or the new Evenflo Triumph Advance ... then save towards a more dedicated booster for the future.

The (EB) Alpha Omega's top harness slot being safe only for booster mode is also counterintuitive & as such this seat is very often dangerously misused: I despise it for that reason alone.

[cdncasper]

I am almost positive the OP is from Canada so we don't have the uptown or the new triumph. I would suggest either the Radian or a Marathon or even the Scenera and than a harnessed booster later on.

[dd9736]

I am almost positive the OP is from Canada so we don't have the uptown or the new triumph. I would suggest either the Radian or a Marathon or even the Scenera and than a harnessed booster later on.

We're actually going to do that, I told DH that since we'd need another new carseat in a year, we could get a better one now then switch to a ffing carseat booster combo when the new baby needs the rfing convertable. I think he understood before we went to bed why I wanted what I asked for.

[jenmann21]

DH just brought home the eddie bauer 3in1 carseat for our DS, he is 8months old, 16-17lbs, and 70cm tall. I tried DS in the carseat fully reclined, as the instructions state, and could not get the harness slots below his shoulders, even on it's lowest setting, they were sitting at his shoulders, while he was wearing a bulky bedtime cloth diaper, which adds an extra 1/2" from the seat to his shoulders.
How can the manufacturer, or anyone else claim that a newborn could fit in this seat? DS has outgrown his old seat by height, yet is to short for the straps on this seat.
I would like to get some more info on the seat, just incase DH doesn't agree that it doesn't fit properly.

I just helped a mom today who had a brand new EB 3 in 1 seat. She's pg and planning to bring home baby in this. We had to take the base off to get the recline appropriate for a newborn. But I, like you, am worried that the straps are going to be above his shoulders when they bring him home. :( It doesn't look like it's going to fit a newborn well at all.